Connection

Aidoo Hitachi RPI Wi-Fi controller

The unit controller must remain working in parallel with your Aidoo.

Perform all of the connections with a total absence of power.

Follow these steps to connect them:

Fix your Aidoo close to the AC unit to be controlled using the material supplied (double-sided adhesive tape or screws).

Important: Check that you have a Wi-Fi signal available before fixing it.
Set as operating temperature the measurement of the Hitachi thermostat probe, access Function selection and set the value 1 in the parameter C8 (refer to the installation manual of the thermostat).
Disconnect the indoor unit.
Connect the Aidoo to power supply.
Connect the Aidoo to the terminals A and B of the indoor unit using the supplied cable.
Power the indoor unit. Check the LED:
green (blinking)
red (solid)