Connection

Aidoo Gree U-Match R32 Wi-Fi controller

The Gree unit controller must remain working in parallel with your Aidoo.

Perform all of the connections with a total absence of power.

Follow these steps to connect them:

Fix your Aidoo close to the AC unit to be controlled using the material supplied (double-sided adhesive tape or screws).

Important: Check that you have a Wi-Fi signal available before fixing it.
Access to the setting interface of the Gree thermostat and set the value 01 in the function 10. Access to the unit address settings menu of the Gree thermostat and set the value 01 (refer to the service manual of the Gree units).
Disconnect the indoor unit.
Connect the Aidoo to the terminals COM-BMS and COM1 or COM2 (depending on your unit) of the indoor unit using the supplied cable.
Power the indoor unit. Check the LED:
green (blinking)
red (solid)